Back to Journal
Jobs and rates: why the labour market feeds the RBA's next callPhoto: SiteLogic editorial image

Interest Rates

Jobs and rates: why the labour market feeds the RBA's next call

The Reserve Bank has two jobs: low inflation and full employment. This preview explains how labour force figures feed its rate decisions and what they mean for a Victorian feasibility. It reports no result released after 3 October 2026.

·Written and fact-checked . Published .·4 min read

The ABS lists the September 2026 Labour Force release for Thursday 15 October at 11:30am on its release calendar. This article goes up the evening before. It was written on 3 October and reports nothing from that release. It explains how to read the number once you have it.

The Reserve Bank has a dual mandate: price stability and full employment. Its Statement on the Conduct of Monetary Policy says the Monetary Policy Board should balance the two where necessary. Jobs data therefore bears on every rate decision.

Where the labour market stood on 3 October

The ABS Labour Force release for August 2026 was published on 24 September. The seasonally adjusted unemployment rate was 4.6%, up 0.2 percentage points on the ABS's un-rounded estimates. Employment rose by 39,500 people to 14,836,600. The participation rate was 67.1%.

Victoria sat higher. The seasonally adjusted unemployment rate was 5.2% and the trend rate was 5.1%. Victoria's employment to population ratio was 64.3%, against 63.9% nationally.

The ABS added two notes. It changed how it collects its supplementary surveys. It says any effect on monthly movements is expected to be smaller than normal sampling variability and that the August data is fit for purpose, and it continues to recommend trend data as the best measure of underlying behaviour. The national trend rate was 4.6%. It also adjusted the influence of about 1,390 respondents in one Victorian rotation group, around 2.7% of the August sample. The ABS says it will keep monitoring that group, and it advises caution in reading short-term changes.

Why the RBA watches it

The RBA's explainer on the NAIRU defines it as the lowest unemployment rate that can be sustained without wages growth and inflation rising. When unemployment is below that level, the RBA says the economy is operating above its full capacity and there is upward pressure on inflation.

That link explains the language in the 29 September statement. The Board said labour market conditions had eased broadly as expected in recent months and that leading indicators were broadly stable. It also said growth in aggregate demand needs to stay subdued for a period to reduce capacity pressures. Jobs data is the main check on whether that is happening.

The RBA's August Statement on Monetary Policy projected unemployment rising gradually to 4.8% by the end of 2028. It also noted that some model-based estimates suggest the labour market is tighter than its central forecast assumes. These are the RBA's published projections. They are not outcomes.

Reading the 15 October release

Treat the next figure as a test of the Board's stated view. The table sets out conditional readings. These readings interpret the data. They do not forecast the 3 November decision.

| If the September seasonally adjusted rate is | It would suggest | What to watch next | |---|---|---| | 4.4% or lower | Spare capacity is not building as the RBA assumed | The September monthly CPI on 28 October, which also carries the September quarter figures | | Between 4.5% and 4.7% | Conditions close to the August reading | Hours worked and underemployment | | 4.8% or higher | Demand is easing faster than assumed | Whether trend data confirms it |

One month rarely decides the question. The ABS lists the September monthly CPI for 28 October, which also carries the September quarter figures, and the Board meets on 2 and 3 November. The RBA board meeting schedule confirms the decision date. The Board will weigh the labour data alongside inflation, spending and its own forecasts.

What it means in dollars

The following figures are illustrative. They demonstrate the method and will vary by site, council and timing.

SiteLogic's feasibility default for a holding loan is the cash rate plus a 3.5 point lender margin. At a 4.60% cash rate, that is 8.10%.

  • Average drawn balance over 12 months: $4,000,000.
  • Interest at 8.10%: $4,000,000 × 0.0810 = $324,000.
  • Interest at 8.35%, after a further 25 basis points: $4,000,000 × 0.0835 = $334,000.
  • Difference: $10,000 a year, or $15,000 over an 18-month build.
  • Difference at 50 basis points (8.60%): $20,000 a year, or $30,000 over 18 months.

The jobs data does not change these sums. It is one of the inputs the Board has said it will weigh. A strong reading would sit with the Board's concern about capacity pressures. A weak one would sit on the employment side of its mandate.

Employment also reaches your revenue line. Buyers need secure income to pass a lender's serviceability test. Victoria's higher unemployment rate is a reason to test presale conversion at a lower figure than your national assumptions imply.

What to check

  • The release date. Confirm 15 October on the ABS calendar before you plan around it.
  • Trend as well as seasonally adjusted data. Read both for Victoria.
  • Your rate assumption. Keep the current rate as the base case and run +25 and +50 basis point columns beside it.
  • Your buyer depth. The Vic development conditions panel tracks housing loans by number against a year earlier.
  • Your facility terms. Check whether the margin is fixed and what triggers a repricing.

This is general information and not financial advice.


Published by the SiteLogic Editorial desk. Every fact traces to a primary source. See our standards and corrections register.

Fact-checked: 3 October 2026 · Review by: 3 January 2027

Sources: abs.gov.au · abs.gov.au · rba.gov.au · rba.gov.au · rba.gov.au · rba.gov.au · rba.gov.au

Our standards·

Share this article

Get new articles by email

Weekly digest of new articles. No spam. Unsubscribe any time.

Was this useful? Try the tool this post is based on:

Pro on SiteLogic. Logi: up to 60 messages a day. Logi also stops at US$15 of model cost in a Melbourne calendar month. The Developer Comms Kit and unlimited saved projects. The Strategy Lab simulator runs without Pro. Saving a scenario needs a signed-in account. $60/month or $600/year, ex GST. First 3 months are $30/month, ex GST, on monthly Pro.

See Pro pricingFree tier stays free.